Discussion de forum
Terminal frozen displaying 1057
My 4K PVR is frozen with "1057" on the display. It doesn't respond to the remote or the power button. When I unplug it and plug it in again it says "boot" for a few seconds and then shows "1057". ...
Customer Service recognized the problem instantly. All I had to do was boot with the HDMI cable unplugged.
You would be best to call technical support about this...
my guess would be it’s either a problem with the hard disk drive or problem with the signal... but there a good chance it’s something with the HDD... because if it was the signal, you would still be able to see something on the screen.
You're probably right. I forgot to mention, my other PVR and internet are working so the signal's fine except for the unlikely possibility of a cable going bad.
