Discussion de forum
Résolu
Helix fi channel
Hi. I would like to know if any body know how to change the channel on the helix fi admin account. Its actually on the channel 11 and I have to much people around me on the same channel. I've try t...
Hi! Although it is technically possible to operate a Helix Fi pod in this way, the maneuver is neither recommended nor supported. The use of the ethernet jack on the Pods should be limited to connect devices that have no Wi-Fi capability.
A cable connection from the Helix Fi gateway to the Pods can cause unexpected behavior in the Helix ecosystem and thus you would be exposed to unknown and unsupported bugs that are not documented on our side nor our partners.
In case of a poor Wi-Fi signal, it would be best contact the technical support team who will be able to make the appropriate troubleshooting more easily with you.
I ran a WiFi scan using my phone at various points in my apartment and found that my Helix router has chosen literally the worst possible WiFi channels. Any help fixing this would be appreciated.
Hello Kayosweaver!
As long as the band-steering feature is enabled (both networks are joined under one SSID), the Helix Gateway will analyze the Wi-Fi environment and adapt by selecting the best channels and bands for each device. This process can take up to 48 hours.
If you have separated the bands, thus disabling band-steering via Helix Fi, you can manually select channels in your Wi-Fi network settings. If channel selection is left automated, like most routers, the Gateway will also scan and automatically select the least congested channel when rebooted.
I hope this helps!
-JFrancoisD
Hi FrancoisD,
currently, I have 2 separate wifi SSID for 2.4G and 5G. I have a device on the 2.4G wifi that connect intermintently, probaly due to interferencies, I want to change manually the channel used for the 2.4G from 11 to 6 or 1, I had a very good connexion before (I was on Bell), and this problem is new. Also, please tell me where we can find the RF Power Level control.
Actually, the Helix FI is located in my home basement, where there is practically no RF coming from outside to the router, so I suspect the Helix FI doesn't "see" all the interferencies present at the ground floor, and unfortunately, it choose a bad channel, it is necessary to adjust manually the correct channel.
Thanks
FrançoisB
