HELIX (mode bridge) et IPv6 sur pfSense

There was a time where it would be irrelevant; as the benefit would never be tangiby-felt, but now its starting to change with Videotron offering > 50mbit internet, video streaming, and high-bandwidth applications.

Case-in-point:

- If you're in an urban apartment building: 5Ghz only.  This is because the sheer amount of 2.4ghz devices in your physical surrounding, that makes it literally impossible to have a fully-clear channel for your wifi to operate, and if you crave bandwidth; you will be best-served with 5Ghz. 

- If you're in a residential neighborhood (without anybody stacked on top and below you) then, you'll want to use both 2.4Ghz and 5Ghz by having both networks using the same SSID (wifi name), and you might even want to consider a central location where to put your router (main floor, centrally-located, and forget the old basement computer desk that nobody uses anymore).    

5Ghz allows you to reach must higher bandwidths (up to 1300mbps in some cases), while 2.4Ghz maxes-out at 300/450mbit, both in ideal conditions (which never happens; usually perfect condition flank speed is about half of that).

Also, there's a question of spectrum; 2.4ghz goes easier through walls than 5ghz.   5Ghz covers a single-bedroom apartment well, while it won't ensure an entire 2-story house, so thats where 2.4ghz comes-in.

Great read:

https://lifehacker.com/5931743/top-10-ways-to-boost-your-home-wi-fi