Profil de l'utilisateur
aarmouti
Initiate
Inscrit le il y a 3 ans
Widgets de l'utilisateur
Contributions
Helix Bridge Mode
Hello, I have a question regarding Helix Bridge Mode. My Current setup is as follows: Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 1 8 WS-C2960G-8TC-L 12.2(52)SE C2960-LANBASEK9-M modem is pluggedinto a managed switch in this case a Cisco 2960G in port Gi0/7 as an access port as seen below: CAQCIDSCORESW#show running-config interface gigabitEthernet 0/7 Building configuration... Current configuration : 117 bytes ! interface GigabitEthernet0/7 description ISP1-TBD switchport access vlan 10 switchport mode access end from there the switch is trunked into a 2nd Cisco 2960G on port Gi0/8 on both sides as seen below: CAQCIDSCORESW#show running-config interface gigabitEthernet 0/8 Building configuration... Current configuration : 170 bytes ! interface GigabitEthernet0/8 description UPLINK-CAQCIDSACCSW01 switchport trunk allowed vlan 10,11,20,30,60,70,80,306,403,404,500-507,806 switchport mode trunk end CAQCIDSACCSW01#show running-config interface gigabitEthernet 0/8 Building configuration... Current configuration : 169 bytes ! interface GigabitEthernet0/8 description UPLINK-CAQCIDSCORESW switchport trunk allowed vlan 10,11,20,30,60,70,80,306,403,404,500-507,806 switchport mode trunk end From there, the PFSense Firewall is plugged into port Gi0/7 as seen below: CAQCIDSACCSW01#show running-config interface gigabitEthernet 0/7 Building configuration... Current configuration : 138 bytes ! interface GigabitEthernet0/7 description CAQCIDSFW switchport trunk allowed vlan 10,11,80,403,404,500-507 switchport mode trunk end VLAN10 is present in both switches databases as seen below: CAQCIDSACCSW01#show vlan brief | i WANG 10LEGACY-NETWORK-WANG active CAQCIDSCORESW#show vlan brief | i WANG 10LEGACY-NETWORK-WANG active Gi0/7 As seen from the setup, the switches only work on L2 and there is only one SVI used for management which is in VLAN500 172.30.0.0/24. My question is: Will the PFSense Firewall pull a Public IP Address from Videotron's DHCP Servers? I am assuming the DHCPDISCOVER packet leaving the PFSense would be routed to the DHCP Servers with something like an "ip helper address"? I am assuming that putting the Helix in Bridge Mode will disable all L3 capabilities, if thats the case, how can it be accessed after? Or simply a Factory-Reset? Thank You!4,6 kVues0like1Commentaire