Discussion de forum
Mesh Network - Réseau maillé
Depuis que je suis passé de Bell à Vidéotron, j’ai remarqué que ma maison présente quelques zones mortes en termes de Wi-Fi, surtout à l’extérieur, ce qui affecte certains appareils intelligents comm...
target1plus federal marketplace wrote:Since switching from Bell to Videotron, I've noticed that my house has some dead zones in terms of Wi-Fi, especially outside, which affects some smart devices like cameras and connected plugs.
To solve this problem, I want to buy a TP-Link Deco X20 kit. However, there are three ways to set it up:
New Router : The first Deco becomes a new router, creating a single mesh Wi-Fi network with the other Deco units. This means I will have two separate networks in the house: the Helix base station and the Deco X20 mesh network. I have read online that this can cause issues with two NATs.
Bridge mode : I activate the bridge mode of the Helix-Fi terminal, making only the Deco X20 mesh network functional. However, I read on this forum that this could cause problems with Helix TV, in particular the voice functions of the remote controls.
AP (Access Point) mode : I activate the AP mode of the Deco X20 units and deactivate the Wi-Fi of the Helix Fi terminal. In this case, there is only one NAT, that of the Helix Fi terminal, and only one Wi-Fi network, that of the Deco X20s.
However, I found very little information on the third point, which is my preference at the moment. Could this cause problems with Helix TV terminals and their remote controls?
THANKS!
Setting up your TP-Link Deco X20 in AP (Access Point) mode is a solid choice, especially for simplifying your network. In this mode, the Deco units will act as additional access points while the Helix terminal handles routing. This way, you'll have a single Wi-Fi network, which can help avoid issues related to multiple NATs.
As for your concerns regarding Helix TV and remote controls, using AP mode generally should not cause problems. The Helix terminal will still handle all the necessary routing and TV functionalities, and the Deco units will just extend the Wi-Fi coverage. However, it's always a good idea to check for any specific updates or compatibility issues related to your Helix equipment, as setups can sometimes vary based on firmware versions.
If you decide to go with AP mode, make sure to disable the Wi-Fi on the Helix terminal and connect the Deco units directly to it via Ethernet. This should optimize performance and coverage without disrupting your Helix services.
If you run into any issues with Helix TV after the switch, you might need to tweak some settings or consult with Videotron support for additional guidance. But in general, AP mode is a straightforward solution for enhancing your Wi-Fi coverage.
